topblog Ivoire blogs

30/09/2018

K+DCAN usb for 545 e60 2005 programming and coding results

I can show you my programming and coding results few day before for my 545 e60 2005..with K DCAN usb...

Requirements for installation of ISTA P : min 200 gb free hdd,min 3-4gb RAM,and min 2ghz cpu speed,i hope you know...

I don't know for sure do you need to keep ISTA +,because I have installed Ista + before ISTA P version 3.65.0.500 which I have...

I don't remember thru that installation of ISTA P that I was needed some kind of activation key, only reg fix or something ...but anyway, now I have a new version of ISTA P3.65.0.500 so you can go thru installation of 3.65.0.500 version [85 gb]...[there is ISTA P loader folder with activation key ]

About my experience, I must tell you that with K DCAN usb cable everything was fine but slow...

For my CCC Application programming time was about 8 hours!!!

Everything else was much faster,  think I have 38 ecu programmed and coded thru ISTA P....

I have done full car programming in about 12 hours!!!

Yes I know it is crazy, but when it started, I must to finish everything...

BMW ICOM is much better[and faster] solution!

But for my car it was a problem for old ZSUB numbers which I did not managed to program

all ecu-s thru WinKFP ,one by one..only few of them.

Everything about ecu-s in my bmw was from 2005 [integration level plant E060-04-09-550]

Anyway I think there is no problem for programming 1 ecu with K DCAN usb, but keep in mind that voltage of the battery must be backup all the time and key must be on ignition position ...

And one more thing, for me WinKFP is also good solution for programming, because when you have new ZSUB numbers {ecu numbers} ,you just need to find that number in AIF thru INPA, and after that you just in WInKFP comfort mode [F1] ,put that number [F1],enter VIN [F4],than DONE[F8] and than [F3] again and everything is done!

Or just update ecu with [F3],than select ecu family,enter VIN [F4],than [F8] and again [F3]...

I hope you don't mind for this long thread, and also sorry for my English writing ,because I don't know better...

PS:ISTA P is only for programming and coding ,not for diagnostic....so keep your ISTA +

BMW E60 ISTA /P final report:

https://mega.nz/#!gZwBXIaS!KWoT-7k4zsU21zvBvOXC2Wu95_-heL...

 

www.obd2eshop.com

 

Source:

http://blog.obd2eshop.com/kdcan-usb-for-545-e60-2005-prog...

09:37 Publié dans Blog | Tags : bmw icom | Lien permanent | Commentaires (0)

Les commentaires sont fermés.