topblog Ivoire blogs

18/10/2018

How to use wiTech MicroPod 2 to work with Enhanced DRB III Emulator?

Here is the test repport from mhhauto.com,For How to use  wiTech MicroPod 2 V17.04.27 to get Enhanced DRB III Emulator to work:

1: Make a backup copy of the partition from the hard drive included with the micropod!

2: Install HDD in laptop

3: Set date to 01/01/17 BEFORE booting from laptop

4: Boot to HDD

5: Allow windows to install drivers, etc, as needed for your laptop and reboot as needed.

6: Once all of that is done, do NOT run WiTech yet!

7: Turn OFF internet!

8: Navigate to C:ProgramDatawiTECHjserverdatacorestubs

9: Install DRB Emulator stub

10: Install DRB Enhanced emulator stub

11: Install K-Line stub

12: Reboot computer

13: Set date back to current date

14: ALLOW internet access

15: Run Flexnet software updater. Do NOT update WiTech!!!

16: Flexnet will find updates for enhanced DRB and K-Line

17: Install K-Line update first

18: Install Enhanced update next.

19: Turn date back to 01/01/17!

20: Once updates and downloaded and installed, turn OFF internet and NEVER turn on again!

21: Reboot computer

22: Attach Micropod to car. When green LED turns on, turn on car ignition

23: Attach USB cable to PC and Micropod

24: When Windows is done installing drivers, etc, you should show a network connection in the tool tray with no internet access

25: Run Wi-Tech

26: Press “Launch DRB III” button in lower right hand corner

27: Accept EULA

28: DRB Emulator will launch.

29: Enjoy.

 

Actually, many of users already verified the wiTech MicroPod 2 V17.04.27 clone from the following site can work as fine as the above user’s:

http://blog.obd2eshop.com/

 

 

11:01 Publié dans Blog | Tags : witech micropod 2 | Lien permanent | Commentaires (0)

Les commentaires sont fermés.