topblog Ivoire blogs

04/05/2016

Original Xhorse VVDI 2 V1.1.3 free download

Original Xhorse VVDI 2 VVDI II Key Programmer software newly updated to V1.1.3.

click to free download vvdi ii 1.1.3

This is the newest information of Xhorse VVDI2 V1.1.3.
===== VAG V1.1.3 =====
1. Add decode 95160 EEPROM for touareg 2008
2. Fixbug for read PIN and CS in med17.5 ECU
3. Fixbug for passat B6 find 7th bytes CS
4. Added guided functions: ECU/ABS following: (other modules will add soon)(Menu->Diagnostic->Guided Functions)

Engine:
Activation of cruise control
Throttle adaptation - Otto engines with Drive-By-Wire
Turning on Pre-Fuel pump (eg. for bleeding)
Injectors checking 3.0/2.7 TDI
Pump-jet checking 1.9/2.0 TDI
Adaptation of turbocharger in 2.7/3.0TDi engines
Adaptation of flap motors in 3.0/2.7 TDi engines
Testing Mass air flow meter G70 in TDI engines
Chiptuning test
Adaptation of G336 sensor (intake manifold's flaps) in 2.0TFSi BPY/AXX
Adaptation of Turbocharger sensors used in CBAB CBAC 2.0TDi CR engines
Adaptation of EGR valve in Gasoline engines
Adaptation of start quantity in TDI VP Engines
Start/Stop deactivation in MQB cars (Golf 7, Octavia 3 etc)

ABS:
Calibration of G85 sensor
FillingUp Brake system (MK60/70 - Golf V / Passat / Altea / Leon)
Enable / Disable "SystemTest" for ABS/ESP
Calibration of ESP acceleration sensor G200
Calibration of ESP pressure sensor G201
Calibration of ESP acceleration sensor G251
LHD/RHD ESP Coding
Recoding ABS/ESP variant (USA/EU)
ESP sensor calibration G200,G202,G251 in cars newer than 06.2007
Adaptation ESP ECU for DSG Gearbox in Audi A3 8P MJ2006
Total deactivation/activation of ESP MK60EC1

===== BMW V1.1.3 =====
1. Add support for lost all key with newest firmware: 9395656, 9395657, 9389115, 9389116
2. Improvement file make key window, show VIN, key cutting code, remote frequency, ISN etc
3. Add disable/enable key for CAS1/2/3/3+/4/4+ in file make key
4. Fixbug for EWS4 KM
5. Fixbug for change KM 5M48H with error checksum
6. Bugfix

===== Porsche V1.0.5 =====
1. Bugfix

===== Transponder Programmer V1.1.3 =====
1. Add new window for Hitag3, support read/write page with password
2. Immo data tool bugfix: Renault Trucks Magnum 2000 - 93C46
3. Immo data tool bugfix: Daihastu Sirion -2003 93C66(4C)
4. Immo data tool bugfix: Euro Gilear Fuoco ST10F269
5. Immo data tool bugfix: Ducati Monster 696
6. Immo data tool bugfix: Renault Laguna II 95160
7. Immo data tool bugfix: Mercedes benz Vito 68HC
8. Immo data tool add new for toyota 93C66
9. Bugfix

xhorse-pro-vvdi-2-ii-key-programmer-a-11.jpg

How to online update xhorse VVDI2 Key Programmer

10:54 Publié dans Blog, Shopping, Web | Lien permanent | Commentaires (0)

27/04/2016

2016 New BMW K+Dcan cable with switch vs. Old INPA Dcan cable

OBD2EXPRESS nowadays release the newest BMW INPA K+Dcan cable with switch and FT232RQ chip, which confused some customers. Here is the comparison of 2016 new and old K+Dcan cable.

     2016 NEW K+Dcan interface   vs.     OLD Dcan interface

old-new-k+dcan-inpa-cable-switch-1.jpg
Both BMW INPA K+CAN cables can:
1. Read and delete errors
2. Adaptations
3. Driver programming
4. Applu coding
...
Free Download: BMW INPA K+CAN Software

new K+DCAN cable (US$18.15):
1- new switch

k+dcan-inpa-cable-switch-2.jpg
the switch on this cable to LEFT is for 7 pin, to RIGHT for 8 pin
8 pin for K-LINE communication (old DCAN cables cannot do it) for BMW from 1998 to 2008

2- new PCB
with FT232RQ chip

k+dcan-inpa-cable-switch-pcb-3.jpg

 

k+dcan-inpa-cable-switch-pcb-4.jpg

the printed circuited board of better quality than the old one

old k+dcan cables (US$14.19):
1- No switch
2- only D-CAN for
- E60, E61 od 03/2007
- E83 od 09/2006
- E81, E87 od 03/2007
- E90, E91, E92, E93 od 03/2007
- E70 (new model X5)
- R56 (new model MINI)
3- Old PCB of good quality
with FT232RL chip

K+DCAN cable-pcb board-5.jpg

K+DCAN cable-pcb board-6.jpg
Customer review - “Warning for bad K+DCAN cable
I can’t help complaining the bad K+DCAN cable I used before. It was burned, you know.
Typical terrible Chinese layout PCB design. In fact it has fresh burn marks on it making me pretty sure an arc from those is what took out the cable. If I end up with another one I will cut those back and cover in hot glue or something to isolate from the FT232 chip. Pic below doesn't quite do justice to how burned that thing looks in person.

The big device they use turns out to be an L7805V voltage regulator. Without getting into reverse engineering their schematic I'm guessing they have something setup very inefficiently so it is shunting tons of current to generate the 5V but I dunno.

BlownKDCAN-7.jpg
Here's (not much but a little) better shot of how burnt the poor FT232 chip is... blurry but you can see the discoloration...

BlownKDCAN-8.jpg
Well... Had better to buy a new one.
I must say, I am the lucky dog. Get the great one you see.

BMW INPA K+CAN FT232RL-pcb-9.jpg

BMW INPA K+CAN FT232RL-pcb-10.jpg
Very fine work, and bridged soldering of 2 pins is intentional.

A successful purchase in China I think.

Ps. The new with good PCB site:
http://www.obdexpress.co.uk/wholesale/new-bmw-inpa-k+can-...

BMW-INPA-K-Dcan-With-Switch-11.jpg

09:27 Publié dans Blog, Shopping, Web | Lien permanent | Commentaires (0)

26/04/2016

Porsche PIWIS Tester 2 V16.7 coming soon!

PIWIS Tester II v16.700 will be released at obd2express. Here is some basic information of PIWIS II 16.7.

porsche-piwis-tester-ii-16.7 (1).png
We have tested both normal PIWIS Tester II and PIWIS II Wifi version with Porsche software v16.7---> work no problem.
PIWIS II 16.700 update steps is exactly same as previous version:
1. Please insert the PIWIS 2 16.700 DVD into DVD rom, then choose [Tools- DVD Upgrade] the software will install automatically.
2. Choose [Yes].
3. Click [OK] to update.
4.Wait patiently for around 4-7 hours (for me it costs 6:42 hours to install, via CF-30 laptop CPU: 9300 4GB RAM) to finish update.
5. Tester 2 16.7 update success, and restart the laptop.
If the laptop not restart automatically, you must manual restart it, after restart, the software screen will change PIWIS Tester II V16.700.

Piwis tester 2 v16.7 display:
Porsche piwis 2 v16.7 upgrade preparation:

porsche-piwis-tester-ii-16.7 (2).png
PIWIS TESTER II V16.700 installation ready to use

porsche-piwis-tester-ii-16.7 (3).png
PIWIS TESTER II V16.700 Version Details:
Release version: 16.700
VCI configuration: 3.5.1.0
Fault finding application: 2.0.0.153
Wiring diagram application: v1.4.0

porsche-piwis-tester-ii-16.7 (4).png
Wiring diagram application: v1.4.0

porsche-piwis-tester-ii-16.7 (5).png
Newest Porsche piwis tester ii v16.7 will come soon at obdexpress.co.uk

09:46 Publié dans Blog, Shopping, Web | Lien permanent | Commentaires (0)